Vektor Update

 

With the Vektor PC software you can easily update your VCU and your display. The PC software automatically downloads the latest data for the VCU and the display.

Note:

The update to the new version 2.0 can not be done with the original 4 GB SD card. The update can be performed either with the new 8 GB card offered by us or a conventional brand SD card up to 32 GB. Since we cannot test every SD card in advance, the update may fail if the card is not suitable. A failed update will not cause any damage, you just have to use another card. The SD card used must remain in the VCU.

 

Quick guide:

After double clicking on the .EXE the update program opens. Now take the new Vektor 8 GB SD card or a brand card 8-32GB and insert it into your PC.

Select the drive from the list, which belongs to your SD card. Then click on “Flash”. Now insert the microSD card back into the VCU.

Start the engine. First the display does an update. After this is done successfully, the VCU will be updated. Please note that during the VCU update the display is off. After the successful update the display starts as usual. The update process must not be interrupted. The whole process takes about 20 minutes. The update process is only complete when the “POWER” LED is lit continuously.

For further information, please refer to the instructions on page 36.